M7 PA-111 Manual De Instrucciones página 4

Maintenance:
1. Disassemble and clean all the components inside the front housing with pressured air.
2. Take the piston assembly apart from the air cylinder, clean and apply some pneumatic oil
to both piston and cylinder walls.
3. Rehabilitate the tool by assembling everything back reversely.
4. Refer to the supplied parts list to perform the proper maintenance process before using
this tool.
5. Repeat the same process periodically for regular tool maintenance.
6. Follow all the recycling laws of waste disposal once this tool is no longer usable.
Instructions for selecting proper jaw housing on item # PA-201.
Large jaw housing assembly
PA-201P03, P04 & P05
Large jaw housing
4
All manuals and user guides at all-guides.com
Small jaw housing assembly
PA-201P03A, P04A & P05A
Small jaw housing
These two different housings are easy to be
identified by the internal diameters. Both of them
are supplied together with each PA-201.
To prevent premature failure of the housing, the
operator is required to use the proper jaw housing
based on the rivet size being used.
To prevent premature failure of the housing, the
operator is required to use the proper jaw housing
based on the rivet size being used.
Reference:
1. The large jaw housing assembly includes
components PA-201P03, P04 & P05.
This is suitable for rivet sizes of 6.4mm, 6.0mm or
4.8mm.
2. The small jaw housing assembly includes
components PA-201P3A, P4A & P5A.
This is suitable for rivet sizes of 4.0mm, 3.2mm or
2.4mm.