Loewe bild | Extended operating instructions
Setup
Connecting to an audio system via analogue audio cable
TV set
Analogue ampli er
AUDIO IN
L
R
Use a stereo cinch/jack adaptor cable to connect the audio output AUDIO OUT TOSLINK to the analogue audio input of the audio system.
Connecting to the mains supply
Connect the TV set to a 220-240V mains socket.
Plug the mains supply cable into the mains supply connector (AC IN) of the TV and guide the cable out of the TV as shown on the picture below.
Connect the mains supply plug of the mains supply cable to a power outlet.
Headphones
Connecting wired headphones
To connect wired headphones to the TV, connect them to the 3.5mm audio output, labelled "AUDIO OUT" or "AUDIO OUT/TOSLINK".
Connecting Bluetooth headphones
Press
(menu) button and go to [Settings] -> [Network] -> [Bluetooth].
Ensure that [Bluetooth] menu item is turned on.
Switch the Bluetooth headphones to pairing mode. For the procedure, refer to the user manual of the headset.
Enter [Equipment Management] menu.
Your headphones should appear in the list of [Available devices].
Select them and confirm with OK to pair headphones with the TV.
Note: According to manufacturer/type of your Bluetooth device, the volume can be adjusted directly on the playback device.
Note: If you experience Bluetooth connection quality issues, such as dropouts and disconnections, try shortening the distance between
the headphones and the TV.
To unpair Bluetooth headhones:
Press
(menu) button and go to [Settings] -> [Network] -> [Bluetooth] -> [Equipment Management].
In the list of Bluetooth devices, select the device you want to unpair and press OK.
Headphone settings
Press
(menu) button and go to [Settings] -> [Sound] -> [Headphone].
Note: [Headphone] menu is available only when headphones are connected to the TV.
You can change these settings:
[Headphone mode] – Select behaviour of the TV speakers when headphones are connected.
AUDIO
OUT/
TOSLINK
59