Automatic Fault Warnings And What To Do - VALBERG WF 814 B AID DG 701T Instrucciones De Uso

C
Useful information
FAULT POSSIBLE CAUSE
Non-dissolving particles of some
Laundry has
detergents may appear on your
detergent residue.
laundry as white spots.
Grey spots appear on There is untreated oil, cream or
the laundry. ointment on your laundry.
The spin cycle does
No fault. The Unbalanced
not take place or
load control system has been
takes place later
activated.
than expected.
(*) See the chapter regarding maintenance and cleaning of your machine.
(**) See the chapter regarding installation of your machine.
40
TROUBLESHOOTING
Perform an extra rinse, or clean your
laundry with a brush after it dries.
Use the amount of detergent as instructed
on the packaging in the next wash.
The Unbalanced load control system will try
to spread your laundry. The spinning cycle
will begin once your laundry is spread. Load
the drum evenly for the next wash.
EN
C
Useful information

Automatic fault warnings and what to do

Your Washing Machine is equipped with a built-in fault detection system, indicated by a
combination of flashing wash operation lights. The most common failure codes are shown
below.
TROUBLE CODE POSSIBLE FAULT
The door of your machine
E01
is not shut properly.
The water pressure or
E02 the water level inside
the machine may be low.
The pump is faulty or
pump filter is clogged or
E03
electrical connection of
the pump is faulty.
Y o u r m a c h i n e h a s
E04 excessive amount of
water.
(*) See the chapter regarding maintenance and cleaning of your machine.
41
WHAT TO DO
Shut the door properly until you hear a
click. If your machine persists to indicate
fault, turn off your machine, unplug it and
contact the nearest authorised service
agent immediately.
Check the tap is fully turned on. Mains
water may be cut-off. If the problem still
continues, your machine will stop after a
while automatically. Unplug the machine,
turn off your tap and contact the nearest
authorised service agent.
Clean the pump filter. If the problem
persists, contact the nearest authorised
service agent. (*)
Your machine will discharge water by
itself. Once the water has drained, turn
off your machine and unplug it. Turn off
the tap and contact the nearest authorised
service agent.
EN