VALBERG WF 814 B AID DG 701T Instrucciones De Uso página 5

B
Using the appliance
Adjusting the Feet / Adjusting Adjustable Stays
1
 Do not install your machine on a surface (such as carpet) that would prevent ventilation
at the base.
• To ensure silent and vibration-free operation of your machine, install it on a firm surface.
• You can level your machine using the adjustable feet.
• Loosen the plastic locking nut.
 To increase the height of the machine, turn the feet clockwise. To decrease the height
of the machine, turn the feet anticlockwise.
• Once the machine is level, tighten the locking nuts by turning them clockwise.
 Never insert cardboard, wood or other similar materials under the machine to level it.
• When cleaning the ground on which the machine is located, take care not to disturb the
level of the machine.
Electrical Connection
• Your Washing Machine requires a 220- 240V, 50 mains supply.
• The mains cord of your washing machine is equipped with an earthed plug. This plug
should always be inserted to an earthed socket of 10 amps.
2
4
4
X
X
6 EN
B
Using the appliance
• If you do not have a suitable socket and fuse conforming with this, please ensure the
work is carried out by a qualified electrician.
• We do not take responsibility for damage that occurs due to the use of ungrounded
3
equipment.
NOTE
Operating your machine with low voltage will cause
the life cycle of your machine to be reduced and its
performance to be restricted.
Water Inlet Hose Connection
1
 Your machine may have either a single water inlet connection (cold) or double water
inlet connection (hot and cold) depending on the machine specifications. The white capped
hose should be connected to cold water inlet and red capped hose to the hot water inlet (if
applicable).
• To prevent water leaks at the joints, either 1 or 2 nuts (depending on your machine's
specifications) are supplied in the packaging with the hose. Fit these nuts to the end(s) of the
water inlet hose that connect to the water supply.
2 3
7 EN
4