Identification Label; Main Components; Assembly Components - ST 526 A Manual De Instrucciones

IMPORTANT Any damaged or illegible decals
must be replaced. Order replacement decals from
an authorised assistance centre.

3.3 IDENTIFICATION LABEL

The identification label holds the following data
(fig. 1):
1. Manufacturer's address
2. Type of machine
3. Sound power level
4. CE conformity marking
5. Engine operating revolutions
6. Engine power
7. Engine displacement
8. Month / Year of manufacture
9. Serial number
10. Article code
Write the identification data of the machine in the
specific space on the label on the back of the
cover page.
IMPORTANT Use the identification names on
the identification label of the product.
IMPORTANT Use these means of identification
whenever you contact an authorized service
workshop.
IMPORTANT The example of the declaration of
conformity can be found on the last pages of the
manual.

3.4 MAIN COMPONENTS

The machine is made up of the following main
components (fig. 1):
A. Chassis
B. Dashboard
C. Engine
D. Fuel tank
E. Electric starter plug (Optional)
F. Handle for manual start
G. Deflector
H. Exhaust chute
I. Paddle
J. Auger safety guard
K. Auger
L. Levelling skids
M. Lights (optional)
N. Wheel
4. ASSEMBLY
For storage and transport purposes, some
components of the machine are not installed in
the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling and
its packaging, always making use of suitable
equipment. Do not use the machine until all
the indications provided in the "ASSEMBLY"
section have been carried out.
IMPORTANT The machine is supplied without
engine oil or fuel.

4.1 ASSEMBLY COMPONENTS

The packaging holds the components needed for
assembly (fig. 3) listed in the following table:
Pos. Description
A Gear control
B Gear control fasteners
C Screws and nuts for securing
the handle in place
D Gear and deflector adjustment lever grip
E Discharge chute adjustment cable
F Funnel
G Safety key
H Exhaust chute
K Discharge chute sliding ring
L M8 x 20 screws and spring washers
M Chute skids
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the
box.
4. Remove the snow thrower from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 FORWARD AND AUGER CONTROL
CABLE ASSEMBLY
Couple the cable eyelet to the specific opening
(fig. 5).
EN - 5
Q.ty
1
-
4
2
1
1
1
1
10
6
3