Storage; Troubleshooting; Technical Data - Steinbach Pool Professional The Gate Manual Original

2. Unscrew the shower head from both tanks while the second person holds the shower head.
3. Remove the base
4. Unscrew the two pipes
5. Remove the screws from the base of each tank while the second person holds the tank.
6. Drain the remaining water from the tanks. Screw the drain cap
valve into the additional tank.
2
The solar shower is dismantled.

Storage

After thorough cleaning and drying, store the product in a dry and frost-free place (= +5 °C).

Troubleshooting

Fault description
Water is still coming out of the
shower head even after the faucet
has been closed.
Water is leaking from a screw
connection.
There is no water coming out of the
shower head.
The water coming out of the shower
head is not hot.
The water has a bad smell or is
discolored.
If the problem cannot be solved, contact the customer service listed on the last page.

Technical data

Model:
Maximum operating
water pressure:
from the frame .
8 7
from the two tanks.
9
Cause
This is caused by the water heating
up in the unpressurized tank.
The screw connection is not water-
tight.
No water is being supplied.
The water temperature in the tank is
too low.
The filled solar shower has not been
used for some time.
049095PP
5 bar, use a pressure
regulator if required
into the main tank and the vent
13
Remedy
It is not a defect!
Wrap the thread in Teflon tape.
Check the water supply and the
garden hose for damage and
blockages.
Position the solar shower base in an
area with plenty of sunlight.
Drain the tank via the drain cap and
refill it.
Tank volume: 35 l
19