SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
1.
Always disconnect the power supply prior to installing, servicing or removing the LED mirror.
2.
Installation work and electrical wiring must be done by a qualified person(s) in accordance with all appli-
cable codes and standards, including fire-rated construction.
3.
Follow all local building, safety and electrical codes as well as NEC (National Electrical Code) and OSHA
(Occupational Safety and Health Act).
4.
Electric service supply must be 120 volts, 60 hertz.
5.
This product must properly connect to the grounding conductor of the supply circuit.
6.
Do not bend or kink the power wires.
7.
When cutting or drilling into the wall or ceiling, do not damage electrical wiring and other hidden utilities.
8.
Avoid putting sharp or hard objects against mirror surface. Damage and/or injury may occur if punctured.
9.
Turn off product during storms or power surge situations to avoid damage to internal components.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package and
hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement parts.
Estimated Installation Time: 30 minutes
Tools Required for Assembly (not included): Tape Measure, Phillips Screwdriver, Hammer, Electric Drill,
Drill Bits, Level.
Please follow all local electrical codes and consult an electrician when wiring this product.
WIRING DIAGRAM
Mirror
Installation may vary depending on how the previous mirror was installed and the presence of the power
source. Supplies necessary for installation of your new mirror are not all included; however, most are available
at your local home improvement or hardware store.
*House wires may vary in color. Please be sure to verify actual house wires with a certified electrician before
installation.
Homewerks.com
3
House
Electrical
Wires*