Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
WARNING: Turn off power at circuit breaker or remove fuse before attempting installation.
1. Determine the midpoint of where the mirror will be installed
and mark with a pencil. Place the Z-bar (DD) on the wall
with the middle hole of the Z-bar (DD) positioned over the
midpoint.
Hardware Used
DD
Z-bar
2. Using a level, make sure the Z-bar (DD) is straight and
mark the other two holes on the Z-bar (DD) located to the
right and left sides. Remove the Z-bar (DD).
Hardware Used
DD
Z-bar
3. Using a 7/32 in. drill bit (not included), drill holes in the
wall where marked and insert drywall anchors (BB).
Hardware Used
BB
Drywall anchor
4. Place the Z-bar (DD) on the wall and insert the mounting
screws (AA) through the Z-bar (DD) and into the drywall
anchors (BB). Tighten the mounting screws (AA) until the
z-bar (DD) is securely attached to the wall.
Hardware Used
Mounting
AA
screw
DD
Z-bar
1
x 1
2
x 1
3
x 3
4
x 3
x 1
AA
4
DD
DD
A
A
DD
BB
BB
DD
Homewerks.com
Publicidad
Tabla de contenido
