Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
sanding belt runs outward, turn the
tracking adjustment knob clockwise to
correct. If belt runs inward turn adjustment
knob counterclockwise.
Belt life will be greatly increased by
keeping the tracking adjustment set
properly. To prevent the sanding belt from
rubbing against the sander housing, keep
the edge of the belt about 7/64" (2.7mm)
to 13/64" (5.1mm) from the housing as
shown in figure 4.
Edge of housing
4
Changing The Sanding Belt -
Figure 5 & 6
WARNING: To prevent accidental
operation, turn off and unplug sander
before changing the sanding belt.
Pull the lever shown in Figure 5 to
release the tension on the sanding belt.
Pull the sanding belt from the two rollers.
Put the new 3" x 21" (76 x 533mm)
sanding belt in position on the front and
rear rollers (Figure 6). Ensure that the
arrows on the sanding belt and on your
belt sander are pointing in the same
direction. Push the lever to the rear to
tension the sanding belt.
5
6
Edge of belt
Dust Collection - Figure 7
about
7/64" to
WARNING: To prevent accidental
13/64"
operation, turn off and unplug sander
before installing the dust bag.
When using your belt sander, dust and
grit are produced. It is important to use
the provided dust bag to collect dust. You
may also connect the sander to a vacuum
cleaner using the provided vacuum
adaptor. Slide the plastic opening of the
bag or adaptor down over the dust
exhaust port of the sander as shown in
Figure 7. To empty the dust bag, remove
it from the sander and unzip the bag over
a trash container.
7
WARNING: Fire hazard. Collected
sanding dust from sanding surface
coatings (polyurethane, linseed oil,
etc.) can self-ignite in sander dust bag
or elsewhere and cause fire. To reduce
risk, empty bag frequently and strictly
follow sander manual and coating
manufacturer's instructions.
WARNING: Fire hazard. When
working on metal surfaces, do not use
the dust bag or a vacuum cleaner
because sparks are generated. Wear
safety glasses and a dust mask. Due to
the danger of fire, do not use your belt
sander to sand magnesium surfaces. Do
not use for wet sanding.
6
Publicidad
Tabla de contenido
