Modine AGD Serie Manual Tecnico página 39

AGD3
Access
8 8 Disconnect drain connection R1 and position it as to avoid hampering with fan shroud L1.
8 9 Remove deflector L6 and unfasten screws "A" of fan shroud L1.
8 10 Bring fan shroud L1 to the position shown in drawing.
8 11 Models with Ø315 mm fan motors only. To reach the heaters placed under the coil remove the inner drip trays L3 by
unfastening the self-threading screws "B".
8.12 It is possible to reach the header site by unfastening selfthreading screws "C" and removing the side panel L5.
8 13 Models with Ø350 mm fan motors are equipped with the safety system "D" that holds back the fan shroud L1.
Reassembling
8 14 Reposition the drip trays L3 and side panels L5 by fastening self threading screws "B" and "C".
8 15 Reposition the fan shroud L1 and fasten it with screws "A".
8 16 Reposition deflector L6 and reconnect drain connection R1.
L1 = Fan shroud
L2 = Sector
L3 = Inner drip tray
L4 = Supports
L5 = Side panel
L6 = Deflector
R1 = Drain connection
SD = Junction boxes (fans and heaters)
= Ground pole
Figure 5
39
www.modine.com