ZAMST WRIST BAND Manual De Instrucciones página 2

1.
Unfasten all the hook-and-loop fasteners of the product. Confirm the top/bottom and inside/outside of the product.
Strap A
Strap B
<Outside of the product>
2.
Put strap A (side bearing the tag) through the loop bearing the logo to make the product a loop, and slide your hand into
the loop.
Strap A
3.
Adjust strap A and fasten hook-and-loop fastener A.
4.
Adjust strap B and fasten hook-and-loop fastener B before fastening hook-and-loop fastener C.
5.
Make sure that the product is not loose or out of place. If you feel any discomfort, repeat the steps from the beginning to
reattach the product.
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Antislip tape
Loop
<Inside of the product>
Loop
Hook-and-loop
fastener A
Strap A
Hook-and-loop Hook-and-loop
fastener C
fastener B
The product correctly fastened (right hand)
<Back of hand>
Hook-and-loop
fastener A
Tag
Hook-and-loop Hook-and-loop
fastener B fastener C
Put the wrist band with the looped side facing toward your
fingertips.
Pull strap A toward you with your fingers spread open. Ensure
that the wrist band snugly fits your wrist before fastening hook-
and-loop fastener A.
Ensure that the wrist band is not twisted.
<Side view> <Palm of hand>
Attach the product so that the side with the tag
is closest to your fingertip, and that the tag is on
the inside.