Skil PWRCORE 20 HD6294B-00 Manual Del Propietário página 14

CAUTION
Your tool also features 17 clutch settings for the screw-driving operation
will increase as the clutch ring is rotated from 1 to 17. When driving a screw, first try torque
position 1 and increase until the desired torque is reached.
The proper setting depends on the job and the type of bit, fastener, and material you will be
using. In general, use greater torque for larger screws. If the torque is too high, the screws may
be damaged or broken. For delicate operations, such as removing a partially stripped screw,
use a low torque setting.
WORKLIGHT (Fig. 7)
Your tool is equipped with a WORKLIGHT light,
located on the base of the tool. This provides
additional light on the surface of the workpiece
for operation in lower-light areas.
The WORKLIGHT will illuminate in default, low
brightness mode when the tool is turned on
OR if the WORKLIGHT button is depressed
without turning the tool on. You can switch the
brightness from low to full or from full to low by
pressing the WORKLIGHT button.
NOTE: WORKLIGHT will turn off automatically
after 10 seconds of inactivity. In full brightness
mode WORKLIGHT will turn off automatically
after 10 minutes of inactivity.
NOTE: For safety reasons, the WORKLIGHT
button is disabled while the tool is running. The brightness should only be switched when the
tool is not running.
The WORKLIGHT will rapidly flash when the tool and/or battery pack becomes overloaded or
too hot and the internal sensors will turn the tool off. Rest the tool for a while or place the tool
and battery pack separately under air flow for cooling.
The WORKLIGHT will flash more slowly to indicate that the battery pack charge is low.
Recharge the battery pack.
Installing and Removing Bits (Fig. 8a & 8b)
WARNING
attempting to grasp the spinning chuck.
WARNING
Your tool is equipped with a keyless chuck to tighten or release drill bits in the chuck jaws. The
arrow on the chuck indicates the direction in which to rotate the chuck body in order to lock
("CLOSE") or unlock ("OPEN") the chuck jaws on the drill bit.
a. Lock the trigger switch "OFF" on the tool by placing the direction-of-rotation (forward/center-
lock/reverse) selector in the center position.
b. Remove the battery pack and select the Drill Position "
To install the bit:
a. Rotate the chuck body counterclockwise, viewed from chuck end, to open the chuck to
approximately the drill bit diameter.
b. Insert a clean bit up to the drill-bit flutes for small bits, or as far as it will go for large bits.
Close the chuck by rotating the chuck body clockwise and securely tighten it by hand (Fig. 8a).
14
Do not adjust the torque or switch functions while the tool is running .
Do not use the power of the hammer drill while grasping chuck to
loosen or tighten the bit . Friction burn or hand injury is possible if
Do not use bits with damaged shanks.
Fig . 7
WORKLIGHT Button
WORKLIGHT
".
. Output torque