Dyna-Glo Delux RMC-KFA400TDGD Manual Del Usuario E Instrucciones Para El Funcionamiento página 12

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
E.) PHOTOCELL
CLEAN PHOTO CELL ANNUALLY OR AS NEEDED.
- Remove upper shell(See Page 9)
- Remove photocell from photocell Bracket and disconnect photocell from connector.
- Clean photocell lens with cotton swab.
- Inspect photcell lens for damage. If damaged, replace photocell.
F.) FUEL LINES
TIGHTENING FUEL LINES ANNUALLY OR AS NEEDED.
- Remove upper shell (See page 9).
- Use 1/4" wrench and tighten fuel lines(A) at solenoid valve
and at pump. (See Figure 12)
- Remove fan guard (See Figure 13)
- Use 3/8" wrench and tighten fuel lines (B) at pump, pump fuel filter assembly.
- Reinstall fan guard.
BURNER HEAD
SOLENOID
VALVE
FUEL LINE(A)
Figure 12. Tighten fuel line
All manuals and user guides at all-guides.com
PHOTOCELL BRACKET
PHOTOCELL
PHOTOCELL LENS
Figure 11. Clean photocell Lens
FUEL LINE(B)
FUEL LINE(A)
11
CONNECTOR
INSTALL PHOTOCELL
1)INCORRECT
2)CORRECT
FAN GUARD
SCREW
FLAT WASHER
Figure 13. Remove Fan guard