Putting Into Service; Air Supply - avdel 753 MkII Manual De Instrucciones

P u t t i n g i n t o S e r v i c e
A i r S u p p l y
All tools are operated with compressed air at an optimum pressure of 5.5 bar. We recommend the use of pressure regulators and
automatic oiling/filtering systems on the main air supply. To ensure maximum tool life and minimum tool maintenance they should be fitted
within 3 metres of the tool (see diagram below).
Air supply hoses should have a minimum working effective pressure rating of 150% of the maximum pressure produced in the system or 10
bar, whichever is the highest. Air hoses should be oil resistant, have an abrasion resistant exterior and should be armoured where operating
conditions may result in hoses being damaged. All air supply hoses MUST have a minimum bore diameter of 6.4 millimetres or
Read daily servicing details page 22.
Follow the steps below when connecting the tool to the intensifier and main air supply:
•
Push the end of the large hydraulic hose from the tool into the quick release connector on the end of the intensifier.
•
On the front face of the intensifier:
•
Push the blue pneumatic (4mm OD) line into the reducer fitting which is located in the left hand bulkhead connector.
•
Push the black pneumatic (4mm OD) line into the plastic collet of the right hand bulkhead connector.
•
Fit a pneumatic hose between the male connector at the rear of the intensifier and main air supply.
8
1
/ inch.
4