Electrical Wiring Diagram - MSW Motor Technics MSW-M-LP-ABP-800 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
1. When the water level rises to ca. 4.5 cm, the pump will start and continue to run
until the water level drops enough.
2. When the water level is less than 1 cm, the pump will stop.

ELECTRICAL WIRING DIAGRAM

Make sure that the supply voltage is 12 V DC (direct current). Higher voltage will cause
the pump to fail.
1. Use the entire length of the included cable (plus an extension, if required) to
wire it to the pump as shown in the wiring diagram (see Fig. 1).
Fig. 1
A. Brown – manual control
B. Brown/white – automatic control
C. Black
D. Fuse
E.
12V battery

Publicidad

Tabla de contenido
loading

Tabla de contenido