NSK Primado2 Manual Del Usuario página 27

Cleaning / Checking the Irrigation Nozzle
9 – 1 – 2 Automated Cleaning
Automated Cleaning with Cleaning Tools
Use the Cleaning Tools according to the following system figure.
Irrigation Nozzle
_ Pre-cleaning
1 Remove contaminants on the surface with a cloth or soft bristle
brush under running tap water.
≤ 38°C, ≥ 3.5 L/min, ≥ 15 sec.
Water quality: Drinking water
2 Mount the Cleaning Adaptor IN and the Irrigation Nozzle to the
Cleaning Tube 1.5/L25.
Pull the Cleaning Adaptor IN to make sure that it is securely
connected.
* If the Cleaning Tube 1.5/L25 is deteriorated, replace it with a
new one.
Cleaning Tube 1.5/L25
Cleaning
Cleaning Adaptor IN
3 Screw the disposable luer-lock syringe (hereafter referred to as
syringe) into the Cleaning Adaptor IN.
4 Suck tap water from the product tip and discharge it.
Perform this step 5 times.
≤ 38°C
Water quality: Drinking water
5 Remove the Cleaning Tube 1.5/L25 and the Cleaning Adaptor IN
from the Irrigation Nozzle.
26
Drying
Luer-lock syringe
Air Gun
x5