Important Warning; Connections To Be Made - Axxess XSVI-9006-NAV Instrucciones De Instalación

IMPORTANT WARNING

This product includes instructions for an installation which must be care-
fully followed. The instructions are worded in such a manner as to assume
that the Installer is capable of completing this type of electronic installation.
If you are unclear as to what you are instructed to do, or believe that you
do not understand the instructions so as to properly and safely complete
the installation, then you should consult a technician who does have this
knowledge and understanding. Failure to follow these instructions carefully,
and to install the interface as described, could cause harm to the vehicle
or to the safety systems in the vehicle. Interference with certain safety
systems could cause harm to persons as well.
From the XSVI-9006-NAV harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the (2) Red wires to the accessory wire.
• Connect the Orange wire to the illumination wire. (If the aftermarket radio does
not have an illumination wire, tape off the Orange wire.)
• Tape off and disregard the Blue/White wire, it will not be used in this
application.
• Connect the White wire to the left front positive speaker output.
XSVI-9006-NAV

Connections to be made

The following (3) wires are for aftermarket multimedia/navigation radios that provide
2
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker
output.
these wires (if not required, tape them off and disregard them).
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the VSS or speed sense wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
Continued on the next page