Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
F. WALL-MOUNT CONSIDERATIONS
When using this diverter for a wall-mount installation, pay
special attention to the rough-in requirements of the mixer
valve used. Mixer valve rough-in requirements will differ
from those of the diverter. You will need to "jog" the depth
of the piping and connectors, as shown, to make this
installation.
IMPORTANT: If you install this diverter valve to the
shower port of a mixer, you will obtain reduced, and
potentially unsatisfactory, water flow performance.
2. INSTALLATION SEQUENCE
A. BEFORE SOLDERING
Provide an access panel for all installations.
Provide a bath deck/rim or wall surface roughed-in in
accordance with the front page roughing-in dimensions.
Consult the rough-in diagrams for optional outlets and
valves. Allow for access to the connection between the
shower high-pressure hose and the shower interlock
hose.
For easiest installation, do not install the bath unit until all
soldering (except supplies) is complete. Then install the
bath and connect supplies.
Remove the cartridge assembly, as this is most easily
done before the diverter valve is attached to the rim. Use
a wrench, turning counterclockwise, to initially loosen the
cartridge assembly. Then continue to unscrew until free.
Set aside the cartridge assembly.
Jog In Piping
To Shower
Jog In Piping
3
To Hand
Diverter
Shower
Mixer
Valve
Fig. #5
Fig. #6
1506311-2-
A
Publicidad
Tabla de contenido
