Torin BIG RED T91207A Manuel Du Propriétaire página 4

ASSEMBLY
FIGURE 1 - Typical Bottle Jack
Ram
Release
Valve
Handle
Assembly
1. Familiarize yourself with the jack.
2. Attach the 2 handle pieces making sure to align
the holes on both sections.
3. Line up the handle to the handle socket located
on the side of the jack. Then insert the handle
inside the handle socket.
4. Secure the handle in place inside the handle
socket without any vehicle on the jack. Cycle
the lift up and down several times to insure the
hydraulic system is operating properly. (Perform
the System Air Purge Procedure before first use.)
SYSTEM AIR PURGE PROCEDURE
IMPORTANT: BEFORE FIRST USE
Perform the following System Air Purge Procedure to
remove any air that may have been introduced into
the hydraulic system as a result of product shipment
and handling. This step is to be completed without
any weight on the jack.
1. Turn release valve counterclockwise on full turn to
the open position.
Saddle
Extension
Screw
Oil Plug
(on reservior)
Handle
Sleeve
2. Rapidly pump the handle 6-8 times. Leave handle
in down position to expose oil fill plug.
3. With a flat blade screwdriver, push the oil fill plug
slightly to the side to purge trapped air from
system. (Use caution not to tear or puncture the
oil plug.)
4. Turn release valve clockwise to the closed
position.
5. Jack is now ready for use. Check for proper pump
action.
4