Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Before You Begin
WARNING: Risk of scalding. High water temperature can cause severe
burns. Set the valve water temperature at or below 120°F (49°C). Refer to the
temperature adjustment instructions for the valve.
CAUTION: Risk of product damage. Do not apply direct heat to the valve
body when soldering. Excessive heat will damage internal plastic or rubber
components and the plaster guard.
Follow all local plumbing and building codes.
Read these instructions and plan the installation before beginning. Component
location, spacing, and situational requirements can vary.
A mixed water supply is required for this valve.
Do not discard the plaster guard from the valve until instructed to do so.
Turn OFF the water supply.
Kallista
3
1491215-2-A
Publicidad
Tabla de contenido
