Freezer Storage; Freezer Drawers - Sub-Zero Classic Serie Guía De Uso Y Mantenimiento

Ocultar thumbs Ver también para Classic Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
Storage

Freezer Storage

FREEZER DRAWERS

To remove the freezer baskets (over-and-under models):
Pull the drawer open until it stops.
1
2
Lift the upper and lower freezer baskets up and out.
Refer to the illustration below.
To install the freezer baskets (over-and-under models):
1
Insert the lower basket into the four corner retainers.
2
Position the upper basket onto the side rails and slide
back until it clicks.
Expandable freezer basket—for over-and-under models
(excludes 30" model), the left side of the upper freezer
basket is adjustable to allow for tall item storage in the
lower basket. Slide to the right or left to adjust. Refer to
the illustration below.
Freezer basket removal
Expandable freezer basket
To remove a freezer drawer (all freezer and side-by-side
models):
1
Pull the drawer open until it stops.
Pull the two plastic tabs located behind the bottom
2
two corners of the drawer forward, then lift up and out.
Refer to the illustration below.
If the door opening is limited to 90°, the top drawer must
be removed before removing the middle or lower drawer.
To install a freezer drawer (all freezer and side-by-side
models):
Push the drawer slides in.
1
2
Align the drawer with the slides and push back until it
stops.
3
Press down on the front of the drawer to engage the
slides.
TAB
Freezer drawer removal
ICE BIN
To remove the ice bin (over-and-under models):
Pull the freezer drawer open until it stops.
1
2
Lift the ice bin up and out. Refer to the illustration
below.
To remove the ice bin (side-by-side models):
1
Pull the ice bin forward until it stops.
2
Lift the ice bin straight up. Refer to the illustration
below.
3
To install, pull the carrier out and align the bottom of
the ice bin with the carrier.
Slide the ice bin back into position.
4
Over-and-under models
Side-by-side models
To remove the ice bin (side-by-side dispenser models):
1
Pull the ice bin forward until it stops.
Lift to clear the carrier assembly along the back, then
2
pull forward and out. Refer to the illustration below.
Side-by-side dispenser models
subzero.com | 9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Classic icbcl4850s/o

Tabla de contenido