Avidsen 100731 Manual De Instrucciones página 27

HOW TO INSTALL THE CENTRAL UNIT
The central unit does not require wall mounting as the base can be laid on any flat surface.
Choose a safe place and make sure that there is sufficient GSM coverage.
INSTALLATION OF THE WIRELESS PIR
Do not mount the sensor near windows, air conditioning, heating sources, fridge, and oven. Do
not expose to direct sunlight and avoid areas where temperature may undergo sudden changes.
Open the case and remove the PIR strip to activate the batteries. Fix the wall bracket with the
supplied screws and hook the detector. It should be installed at a height of 2.2 meters above
the ground. Adjust the support to change detection distance and angle. The detector is more
sensitive to transverse and vertical movements. If two detectors are installed in the same room,
adjust the position in order to avoid interference and false alarms.
Test
A
B
Top
view
• After one minute self-test, press the test button on the back. Move to the detection field and watch
the LED to make sure that the detector is working.
• The LED indicator flashes once when body motion is detected.
• Adjust the detector angle according to your needs.
This motion detector has smart power saving function. If the detector is triggered
twice within 3 minutes , it enters sleeping state immediately to save power .
During this period , any movement detected does not generate an alarm . After
no movement within the next 3 minutes , it goes back to working state again.
Note: if the detector goes into sleeping state , it is suggested to leave the room
and make sure nobody moves in the detection area . The detector will go back
to working state in 3 minutes
C
ground
Side
view
2,2 m
above
Top
GB
7