4 INFLATING AND SETTING UP
NOTE!
Tighten the valve before inflating!
The valve must be tightened before the first inflation. If the valve is loose, air will leak
from the outer edges of the valve and the board will deflate. Tighten the valve with
the wrench tool included in the repair kit. Note that the board must be empty when
tightening. Insert the wrench into the slots around the valve, press all the way down
and tighten firmly clockwise.
The valve works by pushing the button in the
middle. The valve must be closed when inflating:
the button in the middle is in the up position. By
pressing the button the valve can be changed
open/closed. When emptying the valve must be
open.
Button down = valve open,
button up = valve closed.
EN
EN
10
Insert the pump hose into the valve by pushing
it to the bottom and turning it clockwise. The
hose is disconnected by turning in the opposite
(counterclockwise) direction.