KUGOO KIRIN B1PRO Manual Del Usuario página 3

FUNCTION
1. Installation: After unpacking, loosen the handle bar & quick release, adjust the
horizontal handle to the right direction, lock the horizontal handle, and gently hold the
brake lever several times, adjust the brake lines to the best condition.
2. On/off: Press the switch button on left handle bar to turn on the E-bike, the dash
board will light up; Press the switch button again to turn off the E-bike.
3. Charging: Connect the charger to the power plug and then to the E-bike. When the
charger indicator turns green from red, it shows full power.
4. Battery status: After booting,the dash board lights up and the electricity shows up, it
has four grids, Corresponding to high power, medium power and low power respectively
5. Braking: Use disc brakes, you can not speed up before fully loosed.
6. Headlight: the headlight is in manual control mode, the control button under the
meter, press it to turn on/off the light.
7. Rrear light: When braking, the rear light will blink slowly; In other conditions, the
rear light will be synchronous with the front light.
8. Zero speed booting: When the E-bike on standby mode, you can accelerate with
speeding bar.
9. Speed up: Please accelerate the Ebike slowly, do not twist the throttle bar too hard, in
case of broken.
10. Cruise control: While riding, keep the handle stationary and ride at a constant speed
for 8 seconds. If you release the handle, it can move at a constant speed. If you brake
again or accelerate again, will cancel the cruise function.
11. Electric mode and Assisting mode: the default of the Ebike is assisting mode, only one
gear. While it is assisting mode, also can use the electric mode.
DC2.1 charge port