universalblue UBH-2300-21 Manual De Instrucciones página 76

It is important to place the wire grill into the oven properly. Do not
allow wire rack to touch rear wall of the oven. Rack positions are
shown in the next figure. You may place a deep tray or a standard
tray in the lower and upper wire racks.
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the
figure, first remove the lower, and than the upper side from
installation location. To install wire racks; reverse the procedure for
removing wire rack.
Replacement of the oven lamp
WARNING: Disconnect power supply and wait for the oven to
cool down to eliminate the risk of electrocution before replacing the
oven lamp. Hot surfaces may cause burns.
Remove the glass protector by rotating it. Using plastic gloves may
help you if you have difficulty in rotating it.
Then, remove the lamp by rotating it, and install the new lamp with
the same specifications. Replace the glass protector, plug the
appliance and complete the replacement procedure. You may now
use your oven.
76