Tabla de contenido
Publicidad
Read First
!
Safety Information
!
Understand and follow operating instructions carefully.
WARNING
!
Identifies hazardous conditions and actions that could cause
BODILY HARM or DEATH.
CAUTION
!
Identifies conditions and actions that could DAMAGE the meter or
equipment under test.
WARNING
!
•When using test leads or probes, keep your fingers behind the
finger guards.
•Remove test lead from Meter before opening the battery door or
meter case.
•Use the Meter only as specified in this manual or the protection
by the Meter might be impaired.
•Always use proper terminals, switch position, and range for
measurements.
•Verify the Meter's operation by measuring a known voltage.
If in doubt, have the Meter serviced.
•Do not apply more than the rated voltage, as marked on Meter,
between terminals or between any terminal and earth ground.
•Only replace the blown fuse with the proper rating as specified
in this manual.
•Use caution with voltages above 30 Vac rms, 42 Vac peak,or 60
Vdc. These voltages pose a shock hazard.
•To avoid false readings that can lead to electric shock and
injury, replace battery as soon as low battery indicator.
•Disconnect circuit power and discharge all high-voltage
capaci-tors before testing resistance, continuity, diodes, or
capacitance.
•Do not use Meter around explosive gas or vapor.
•To reduce the risk of fire or electric shock do not expose this
product to rain or moisture.
1
EN
Publicidad
Tabla de contenido
