Presetting Stations; Recalling A Preset Station - Sangean DMS-37BT Manual De Instrucciones

Presetting stations

You may store your preferred DAB and FM radio stations to the preset station memories ( to
0). The procedure for setting presets and using them to tune stations is the same for FM and
DAB modes, and is described below. Note that the radio stores FM and DAB presets separately
and so there are ten of each. Presets are preserved in the event of a power failure.
. Press the On / Standby button to switch on your sound system.
2. Tune to the required station as previously described.
3. Press and hold down the required Preset button ( to 0) until the display shows for example
"Preset  stored". The station will be stored using the chosen preset number. Repeat this
procedure for the remaining presets as you wish.
4. Preset memories which have already been stored may be overwritten by following the above
procedure if required.

Recalling a preset station

. Press the On / Standby button to switch on your sound system.
2. Select the required waveband by pressing the Source button.
3. Momentarily press the required Preset button (-0) to cause your radio to tune to the station
stored in preset memory.
Note:
If you have not previously stored a preset station and the preset button is pressed "Empty preset"
will be displayed.
GB
20