Publicidad
Idiomas disponibles
Idiomas disponibles
292*210mm
Table 1
A) Fan Motor
B) Wall Fan Mouting
bracket
C) Speed Rotary
Switch
D) Pull for Oscillation
enable / disable
E) Rear Fan Guard
F) Fan Blade
G) Front Fan Guard
H) Mounting Screwx4
for Rear Guard
I) Pull for Speed
1 ,2,3 or OFF
J) Fan Blade
Fastening Bolt
K) Fan Guard snap
lock
OPERATING INSTRUCTION
1) To operate the tan , pull the nylon rape (1) to get the rotary switch to Speed 1 or 2 or 3. To
switch off the tan, pull the nylon rape to get the rotary switch to " O ".
2) Oscillation
ot the tan motor could be ON /OFF by pulling the nylon rape (D) vice versa.
INSTALLATION INSTRUCTION
1) Fix the Wall Fan mouting bracket (B) to wall with screws and wall plugs.
2)
lnsert the rear tan guard (E) to the motor body and tighten with faur screws (H).
3)
lnsert the tan blade (F) into the shatt
4)
Assemble the front fan guard (G) with the rear fan guard (E).
5)
Lock the fan guards by pressing the snap lock (K) whch is surrounding it.
IMPORTANT SAFETY INSTRUCTION & PRECAUTION:
1) Safety Precaution for lnstallation:
*The wall fan is to be installed so that the blades are more than 2.5 meters above the floor (far fan intenced to be mounted
at high level).
2) Safety Precaution for children:
* The appliance is not to be used by persons (induding children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction.
Children being supervised not to play with the appliance.
*
3)
Safety Precaution for user during cleaning:
* Ensure that the fan is switched OFF from supply mains befare removing the guard.
4)
Replacement Cord lnstruction:
* lt the supply cord is damaged, it must be repla:::ed by manufacturer, its service agent or similar qual�ied persons in arder
to avoid a hazard.
WALL FAN
18" (450mm) Model: IF-W18
20" (500mm) Model: IF-W50
Please check and verify all the received components
are in proper /good condition and correct quantity
according to the left table. (Table 1)
ot motor and please make sure the bolt (J) has tully tighten.
--@
ef
Publicidad
