Motion BLINDS CM-40 Manual página 32

10 Set favorite position (optional)
Pull control:
Move the blind to a desired favorite position for
10.1
slide and tilt.
Pull and hold for approximately
10.2
5 seconds until the blind slides left and right.
14
M O TI O N CM - 4 0 D C V E R TIC AL MOT OR
5 s
Remote control:
Move the blind to a desired favorite position for
10.1
slide and tilt.
Activate program mode by shortly pressing the
10.2
program button. The blind will start stepping and
the favorite position can be set.
Hold the centre button to save this favorite position.
10.3
The blind shortly stops stepping indicating the
favorite position has been saved.
Center
Shortly press the program button to deactivate
10.4
program mode. The blind stops stepping and can
be operated.
Short
press