Set Up And Operation - Shop-Vac 2TM Serie Manual Del Usuario

DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover on the tank by aligning tabs with the lugs. Press down firmly on the upper housing
until tank cover snaps into place.
3. Refer to Attach/Detach Toolbox section in this manual and follow the instructions
to open the toolbox.
4. Install dividers into the slots on the toolbox tray. NOTE: Divider will only fit into
slot one way. If it does not slide easily into slot, turn the divider over and insert
opposite end.
5. If desired, attach the vacuum to the toolbox following the instructions and
illustrations in this manual. Vacuum does not need to be attached to the toolbox
to operate.
6. Remove the hose from the toolbox lid and insert machine hose end into inlet
located on top of tank cover. Twist slightly to tighten the connection.
7. Remove one of the cleaning accessories (depending on your cleaning
requirements) from the toolbox lid and attach to accessory end of the hose. Twist
slightly to tighten the connection. NOTE: Many more useful tools are available at
your local dealer or the Shop-Vac
8. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
ACCESSORIES, HOSES AND WANDS
All Shop-Vac vacuums covered in this manual come with accessories to cover wet and dry cleanup jobs.
®
Not all vacs include all accessories shown.
Nozzles and Accessories
Dual Surface Selector Nozzle
Levers control brush position for
various types of cleaning.
Carpet
Tool
Insert
Squeegee
Insert
Deluxe 12" (30.48cm) Nozzle
Inserts snap-in and out.
Elbow swivels.
PAGE 6
All manuals and user guides at all-guides.com

SET UP AND OPERATION

–
This equipment incorporates parts such as switches, motors or the
website.
®
(1.25" (3.18cm)
utility nozzle
shown)
All Friction Fit
Accessories
Insert wand end or hose
into accessory and twist to
form a tight fit.
Brush Insert Shown
Master Nozzle
Inserts lock into place by
sliding insert onto nozzle.
Hoses
All Friction Fit Hoses
Insert machine hose end into
inlet and twist to form a
tight fit.
1
Wands
All Friction Fit Wands
Insert wand ends together
and twist to form a tight fit.