Verdemax SAR40 Manual De Usuario página 27

3) Operation
a) Before starting the machine, make certain
that the feeding chamber is empty.
b) Keep your face and body away from the feed
intake opening.
c) Do not allow hands or any other part of the
body or clothing inside the feeding chamber,
discharge chute, or near any moving part.
d) Keep proper balance and footing at all times.
Do not overreach. Never stand at a higher
level than the base of the machine when
feeding material into it. Always be sure of
your footing on slopes. Walk, never run.
e) Always stand clear of the discharge zone
when operating this machine.
f) When feeding material into the machine be
extremely careful that pieces of metal, rocks,
bottles, cans or other foreign objects are not
included.
g) If the the device strikes any foreign objects
or if the machine should start making any
unusual noise or vibration, immediately shut
off the power source and allow the machine
to stop. Disconnect the machine from the
supply and take the following steps before
restarting and operating the machine:
i) inspect for damage;
ii) replace or repair any damaged parts;
iii) check for and tighten any loose parts.
h) Do not allow processed material to build up
in the discharge zone; this may prevent
proper discharge and can result in kickback
of material through the intake opening.
i) If the machine becomes clogged, shut-off the
power source and disconnect the machine
from supply before cleaning debris.
j) Keep the power source clean of debris and
other accumulations to prevent damage to
the power source or possible fire.
k) Do not transport this machine while the
power source is running.
l) Stop the machine, and remove plug from the
socket. Make sure that all moving parts have
come to a complete stop
- whenever you leave the machine,
- before clearing blockages or unclogging
chute,
- before checking, cleaning or working on
the machine.
EN
m) Do not tilt the machine while the power
source is running.
n) Disconnect the supply (e.g. remove the plug
from the mains or remove the disabling
device)
- whenever the machine is left by the user;
- before clearing a blockage;
- before checking, cleaning or working on
the machine;
- after striking a foreign object to inspect
the machine for damage;
- if the machine starts to vibrate abnormally,
for immediately check.
o) Do not touch moving hazardous parts before
the machine is disconnected from the mains
and the moving hazardous parts have come
to a complete stop.
p) Do not to connect a damaged cord to the
supply or touch a damaged cord before it is
disconnected from the supply for the reason
that damaged cords can lead to contact with
live parts;
q) If the circuit was shorted or a breakdown
happens, overload protector will cut off
power supply automatically.
r) In case of accident or breakdown
immediately stop the machine: Loosen your
grip and the power supply will be cut off
automatically when an accident or
breakdown occurs.
s) If the cord becomes damaged or entangled
during use, loosen the switch and cut the
mains before touching cord.
t) Keep extension cords away from moving
hazardous parts to avoid damages to the
cords which can lead to contact with live
parts.
u) Inspect the machine, the supply and
extension cord for signs of damage or ageing
before and after any use, operate the
machine in a dry, clean and well lightened
place.
v) If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
w) Do not use the power tool if the switch does
not turn it on and off. Any power tool that
cannot be controlled with the switch is
27
Original instructions