Important - Inglesina COPERNICO Manual De Instrucciones

Installing the seat in the forward facing position, from 100 cm to 145 cm
Storing the safety harness away
2e. Once the child has reached a height of 100 cm, the harness should be stored away and the child should be secured
with the vehicle safety belt.
To store the harness away it needs to be fully loosen first, lift the cover and store the buckle parts in the compartment.
Then put the cover back on the seat. Hiding the shoulder pad in the rear side of the upholstery.
2f. IMPORTANT: The support leg is not needed for the 100 - 145cm configuration, raise it so that it does not touch the
floor of the vehicle.
2g. With the child placed in the seat put the vehicle seat belt on passing it through the guide (15). Fasten the vehicle
seat belt buckle and make sure the belt is not too loose.
Gently pulling the diagonal part of the belt before placing the belt over the child's chest.
This child restraint system has a loading position making it easy to place the child in the seat and adjust the straps
to fit correctly.
3a. Turn the seat to the loading position (2b) and open the harness (5). Move the harness straps to the sides to place
the child in the seat.
3b. Place the straps over the child and fasten the buckle.
3c. To adjust the headrest (2) pull the lever (1) on the top. It should be set to the right position, this means that the
shoulder harness should come out approximately l cm above the child's shoulders.
3d. Tighten the harness by pulling the strap (6), it should fit the child snugly.
4a. Once the child is securely strapped in, you can tilt the seat by pressing the lever (7) to the required position.
Getting the child out of the seat
To get the child out of the seat, you should first place the seat in the loading position (2b).
3e. Loosen the harness straps by pressing the adjustment button.
3a. Then unfasten the buckle and get the child out.
Please make sure that the child gets out of the vehicle on the pavement side.
WARNING! The straps should never be twisted.
The harness buckle must be fastened correctly and the straps should fit the child snugly.
38
3. STRAPPING THE CHILD INTO THE SEAT