INSTALLATION INSTRUCTIONS
5. INSTALL THE OPTIONAL DECK-MOUNTED HANDSHOWER MOUNTING TRIM (P24456)
Insert the shank through the hole of the deck. Ensure the O-ring is in the groove under the escutcheon.
Insert the washer and thread the nut underneath the deck and tighten.
Thread on the hose guide and hand tighten.
From the top of the bath or finished deck, insert the smaller end of the flexible hose down through the
escutcheon.
From the underside of the bath or finished deck, insert one washer into the flexible hose.
Tighten the flexible hose onto the water source.
Run cold and hot water through the hoses to flush out dirt and debris.
Insert a washer in the top end of the hose and thread on the handshower holder onto the flexible hose.
Insert a washer into the handshower holder and thread the handshower handle into the handshower holder.
To avoid kinking, remove any twists or loops in the hose.
1491210-2-A
6 of 16
Escutcheon
Washer
Washer
Water Source
Handshower, Hose
& Handshower Accessories
Handshower Handle
Handshower Holder
Washer
Flexible Hose
Shank
Nut
Hose Guide
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.