Steinberg Systems SBS-TW-10B Manual De Instrucciones página 16

MODE:
Cycles between the available units of measurement.
PCS:
1. Press and hold the PCS key when the checkweigher is turned on.
2. Next, press the MODE key to choose the number of weighed pieces
(25/50/75/100).
3. Place the number of pieces selected in the previous step on the
checkweigher.
4. Press the PCS key to confirm.
5. Place the pieces, each of the same weight as before, on the platter to
recount them. The display reads the number of pieces placed on the platter.
If the platter is overloaded, the display reads "O-LD".
3.3.3. AUTO HOLD FEATURE:
With the checkweigher stable, the display reads "HOLD". When the message
flashes twice, the display reading will freeze automatically. The reading will not be
cleared after removing the weighed load from the platter. The display reading will
be unfreezed automatically if another object more than 10 g of weight is placed on
the platter.
3.3.4. CALIBRATION:
1. Place the checkweigher on a flat and level surface.
2. Turn on the checkweigher.
3. Press and hold the MODE key for six seconds, until displays the maximum
load value.
4. Press the MODE key again. The display reads the calibration weight of 2000 g.
5. Press the
6. Press the PCS key to change the calibration weight selection.
7. Press the MODE key to confirm and the display will read "CAL".
8. Place a weight with the mass selected in the previous steps on the platter.
9. After 2-3 seconds, the display will read "PASS" if the checkweigher calibration
is successful.
10. If unsuccessful, the display will read "Err".
11. Press the power (ON/OFF) switch to stop the calibration and try again.
/T key to choose the calibration weight of 2 kg, 12 kg, or 22 kg.