Samsung WW25B6900 Serie Manual Del Usuario página 57

Problem
Excessive suds.
Cannot add additional
detergent.
The washer Stops.
Fills with the wrong
water temperature.
Load is wet at the end of
a cycle.
A2-WW6900_WASHER-MD_SimpleUX_03645H-00_EN.indd 57
• Make sure you use the recommended types of detergent as appropriate.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Reduce the detergent amount for soft water, small loads, or lightly soiled
loads.
• Non-HE detergent is not recommended.
• Make sure the remaining amount of detergent and fabric softener is not
over the limit.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door, and tap and hold
washer will not tumble or spin unless the door is closed.
• Before the washer starts to fill, it will make a series of clicking noises to
check the door lock and will do quick drain.
• There may be a pause or soak period in the cycle. Wait briefly, and the
washer may start.
• Make sure the mesh filter of the water supply hose at the water taps is not
clogged. Periodically clean the mesh filter.
• If the washer is not supplied with sufficient power, the washer will
temporarily not drain or spin. As soon as the washer regains sufficient
power, it will operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush water lines.
• Make sure the water heater is set to supply a minimum of 120 °F (49 °C) hot
water at the tap. Also, check the water heater capacity and recovery rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter may be
clogged.
• While the washer fills, the water temperature may change as the automatic
temperature control feature checks incoming water temperature. This is
normal.
• While the washer fills, you may notice just hot and/or just cold water going
through the dispenser when cold or warm temperatures are selected. This
is a normal function of the automatic temperature control feature as the
washer determines the water temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become unbalanced
and not spin completely.
• Make sure the drain hose is not kinked or clogged.
Action
to start the washer. For your safety, the
English 57
2022/5/23 14:55:36