Assembly
1) Place the rigid axle on the grid floor and secure it with two washers and nuts (M10, 17
mm spanner). Mount the drawbar on the steering axle. The screws (M10x60) pass
through the steering axle from above, through the drawbar and are secured with
washers and nuts (M10, 17 mm spanner).
2) Place the wheels (value point outwards) on the axles. Secure them with a washer and a
safety splint.
3) Put the trolley on its wheels. Attach the handle to the tiller. The handle can be mounted
vertically or horizontally, as desired. Use the M8x60 screw, washers and M8 nut
supplied (13 mm spanner)