Eldom convi HC210 Manual De Instrucciones página 13

GENERAL DESCRIPTION
1. Ventilation openings
2. Handle
3. Supply switch (operation
mode)
4. Indicator light power
5. Thermostat
6. Feet
TECHNICAL DETAILS
Rated power: 1800-2000W
Mains supply:
220-240V ~ 50-60Hz
INTENDED USE
Convector with blower for heating individual rooms (offices, living rooms, etc.). The device is easily portable
and therefore ideal for the transitional heating. The natural convection is intensified by the blower switchable
as needed. He stands firmly on stable feet. At the temperature selector the desired room temperature is
continuously adjustable.
USING THE DEVICE
• After unpacking the device, make sure if it was not damaged during the transport. In case of any doubts,
refrain from its use until contacting a service point.
• Install the feet (6) - pic. 2.
• Place the unit on a flat, stable and heat-resistant floor, min. 2 m away from furniture and flammable objects.
• Set the thermostat (5) in the "MIN" position.
• Connect the device to the power supply source of the parameters compliant with those stated in the user
guide.
• Using the switch (3) select the heating power:
I" for 1250W + TURBO
- "
II" for 2000W+ TURBO
- "
- "I" for 1250W
- "II" for 2000W
• The device will start when temperature is selected with the thermostat knob (5). The maximum operating
temperature is set when the thermostat button (5) is set to "MAX" and the heating level " II" is selected.
• Operation of the device is signalled with the indicating lamp (4).
• During operation of the device, do not cover the heater with clothing or other textiles.
• Do not cover ventilation openings.
• The device has a thermal safeguard cutting off the power supply when it is overheated. In this case, set the
thermostat knob in the "MIN" position, disconnect the device from the power supply and eliminate the cause
of overheating. Leave the device to cool down before switching the device on again.
OPERATING INSTRUCTION
CONVECTOR HEATER WITH TURBO FUNCTION
3
4
5
HC210
2 1
6
EN
PIC. 1
13