Homewerks 7136-02HW Guía De Uso Y Cuidado página 10

Installation - Existing Construction (continued)
6
Securing the suspension brackets
onto the fan housing
□ Secure suspension brackets (EE, FF) to the fan housing (A)
using the two machine screws (BB) and secure suspension
bracket (DD) to the other side of housing using the short
machine screw (CC).
7
Wiring the fan housing
□ Remove the wiring cover from the fan housing (A). Pull
the house wires through the wiring cover hole. Using
the attached quick connectors, secure 120V house
wiring from the wall switch to the fan as shown in
the wiring diagram on page 4. 14 AWG is the smallest
conductor that should be used for branch circuit wiring.
□ Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover.
CAUTION: If the house electrical wires do not match the
colors from the fan wiring diagram on page 4, you must
determine what each house wire represents before
connecting. You may need to consult an electrician
contractor to determine safety.
8
Reconnecting the duct connector
□ Attach the duct connector to the fan housing (A)
with the screws that were set aside when the duct
connector was removed earlier.
Homewerks.com
Slot on the side of the fan housing
DD
CC
EE, FF
House
Wires
Wiring
Cover
10
Quick Connector
Product Wires
A
Duct connector
BB
A
A