Maintenance - Komet TopVac Instrucciones De Operación

Maintenance and Troubleshooting
8.1

Maintenance

Perform the maintenance procedures according to the instructions described in the
following table.
Damages should be repaired by a specialist or by your wholesaler.
When Where
Immediately Exhaust filter splashed or
soaked with oil (can
promote smoke)
Plexiglas cover
Area under the sealing bar
(brass contact surface)
Before starting Cable
operation
Vacuum chamber
Silicon rubber
Cover gasket
Sealing bar and cylinder
(piston rod)
Operating Instructions - Translation
What to do ?
Change exhaust filter
Replace if cover shows signs of
cracks, hairline cracks, deep
scratches or any other damage
Clean it if sealing presents low
quality
Change if damaged
To be cleaned
Teflon band To be cleaned
Change if damaged
Check functioning of cylinders
If necessary , grease it
(Lubricant: sewing-machine oil)
When Where
Weekly Area under the sealing
bar
(brass contact surface)
Sealing cylinder piston
rod
Complete machine
Oil level display
After 6 months Pump
Once a year Exhaust filter
19 04 272 - 01.01.2012
What to do ?
To be cleaned
To be cleaned
Turn on the machine and keep it for
30 minutes at operating temperature,
(or select service program – choice
VAC level P)
through this procedure water present
in the machine oil is removed. To
achieve operating temperature
operate the machine without product.
Control oil level and quality
If necessary, refill machine with oil
(oil type, see Chapter 5: "Technical
Data")
Proceed oil change
Change exhaust filter
Change exhaust filter earlier if there
is: strong soiling or pollution, higher
power consumption, higher
temperature or reduced cutting effect
Eng - 15/20