Service Program For Moisture Removal In The Vacuum Pump; Troubleshooting - Komet TopVac Instrucciones De Operación

Maintenance and Troubleshooting
8.7

Service Program for Moisture Removal in the Vacuum Pump

To remove moisture from the pump, a service program can be used. In approx. 30 min.
it will warm up the pump and remove the condensed water from the oil. The following
procedure should be followed:

Open the lid.

Select the service program for moisture removal from the vacuum pump:
Select the vacuum level VAC P.

Close the lid and the service program will proceed (approx. 30 min.).

To interrupt or stop the service program, press the VAC key.
Operating Instructions - Translation
8.8

Troubleshooting

Problem Possible cause
Poor sealing Sealing bar is dirty
Teflon band is worn out?
Silicon rubber is worn out?
Sealing cylinders are hardly
moving?
No sealing Sealing wire is broken
Insufficient Bag is leaking
vacuum in the
bag
Sharp edge perforate the
bag
Bag is too large for the
product
Insufficient Bad functioning of the
vacuum in the vacuum pump
chamber
Defective cover gasket
Smoke Exhaust filter splashed or
generation soaked with oil
19 04 272 - 01.01.2012
Solution/remedy

Clean the area under the
sealing bar (brass contact
surface).

Change the Teflon band

Change the silicon rubber

Change Teflon band

Change silicon rubber

Grease piston rod

Replace sealing wire

Use another bag

Use thicker bag

Use smaller bag

Check pump oil level

Change oil

Replace cover gasket

Turn off the machine

Unplug the machine from the
power connection

Replace the exhaust filter
Eng - 19/20