QualityCraft MM228-50EDC Manual Del Usuario página 5

Step 10: Attach shelves [L] to the unit as shown in Fig. J.
Step 11: Attach door handles [P] to Left door and right door [M and N] with door
handle screws [O]. Attach Door hinges [R] to left and right door [M and N]
with 8 door mounting screws [S]. See Fig. K.
Step 12: Attach left and right doors to the unit as shown in Fig. L with 8 door
mounting screws [S].
Step 13: Tighten all KD screws.
Fig. J fRONT
Fig. K
fRONT
Fig. l
FirEPlAcE iNSErt iNStAllAtiON
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING: Make sure the fireplace insert controls are in the OFF position and
the unit is NOT plugged in.
Step 1: Carefully place the insert in the unit opening. The front of the insert should be
flush with the front of the mantel. Carefully lift the insert into the mantel until
the top stopper is against the mantel. See Fig. M.
Step 2: Attach 2 L-mounting bracket [U] to the insert with 2 short KD screws [V]. See
Fig. N.
Step 3: Move assembled unit to desired location. Unit should not be positioned in area
exposed to direct sunlight.
5
bACk
Fig. M
Fig. N bACk