Functions And Controls; Main Functions - Breathing Monitor - Nonny BM-03 Instrucciones De Uso

EN | Baby breathing monitor
2.

FUNCTIONS AND CONTROLS

5.
6.
7.
Fig. 3 Control unit - functions
and symbols
1. mechanical on/off button for the monitor
2. optical breathing/alarm signal
3. the NANNY logo works as a capacitive button for light control
4. speaker
5. the indicator light with the power-on symbol - signaling of laying down/
removing the baby, switching from standby to active mode and back or mechanical
button jam
6. low battery indicator
7. room temperature indicator
8. lamp light
9. sockets for the sensor pad cable connector
2.1

MAIN FUNCTIONS - BREATHING MONITOR

Based on signals from the sensor pad located under the baby, the device monitors the
regularity of breathing and signals respiratory arrest.
Inhalation and exhalation are indicated by a green fl ash around the monitor's
mechanical on/off button. The alarm consists of an intense red fl ash around the
mechanical button and a loud acoustic alarm.
The alarm will go off if:
A) No inhalation is detected for 20 secs. 17 secs after the last breath is detected,
a pre-alarm is triggered and the alarm then goes off.
B) The breathing rate is less than 8 breaths per minute. In this case, the alarm goes
off immediately (with no pre-alarm).
6
MXA51105
1.
2.
3.
4.
9.
Fig. 4 Control unit - bottom section
8.