Installation - Nonny BM-03 Instrucciones De Uso

EN | Baby breathing monitor
3.

INSTALLATION

Neither the sensor pad nor the control unit need to be specially cleaned or disinfected
after unpacking. Before using the monitor, make sure that all parts are undamaged.
The device does not require temperature adaptation in connection with its installation
and subsequent repeated use.
1. Place the sensor pad under the
mattress together with a suitable insulating
layer against liquid penetration in the places
where the baby will be lying. The pad must
be placed on a fl at surface with the top print
facing up and must not be bent. If the cot
only has a slat base, support the pad with
a solid board. The board does not have to
cover the entire lower part of the bed - it is
enough if it exceeds the area of the pad by
about 3 cm on each side.
Fig. 7 Securing the connecting
cable
3. Remove the battery cover and insert the
batteries. The battery compartment has
the polarity marked inside for inserting the
battery.
10
MXA51105
Fig. 6 Location of the sensor pad
2. Route and secure the connecting cable
so that the child cannot pull on it and it does
not form loose sections or loops. If you do not
use the entire length of the cable, roll up the
unused part and tighten it tightly with a tie
wire. Keep the roll out of the reach of children.
Fig. 8 Inserting the batteries
4. Connect the connecting cable to any socket
in the control unit. The connector must click
and hold when inserted.
Fig. 9 Connecting the connecting cable
to the control unit