Replacing Auger Blades - SNOWJOE 24V-X4-SB24-CT Manual Del Operador

Fig. 26
Skid shoe
Bolts
3. Install the new skid shoes by tightening the 4 sets of hex
nuts, washers and bolts on both sides, but leave the skid
shoes free to move for height adjustment.
4. Slide skid shoes to flat surface. Allow 1/8 in. (3 mm)
between scraper blade and hard smooth surface. Allow
1‑1/4 in. (30 mm) between scraper blade and uneven or
gravel surfaces.
NOTE: Keep housing level by adjusting skid shoes equally.
5. Retighten the 4 sets of hex nuts and bolts on both sides.
Replacing Scraper Blade
IMPORTANT! Damage to auger/impeller housing will result if
the scraper blade wears down too far.
To replace scraper blade:
1. Position the unit on a hard, flat, smooth level surface.
2. Detach the worn scraper blade from the snow blower by
removing the 5 hex nuts and bolts that hold it in place
(Fig. 27).
Fig. 27
3. Install the new scraper blade and fasten it securely to the
snow blower with 5 hex nuts and bolts (Fig. 27).
13 mm wrench end
Washers Hex nut
Scraper
blade
15
Replacing Shear Bolts
The auger is secured to the auger shaft with shear bolts and
nuts. If the auger should strike a foreign object or ice jam, the
snow blower is designed so that the bolts may shear. If the
auger will not turn, check to see if the bolts have sheared.
m
CAUTION!
Use only manufacturer's recommended
shear bolts for replacement. Use of any other type of shear
bolts may result in severe damage to unit and may void the
warranty. Call the Snow Joe
center at 1‑866‑SNOWJOE (1‑866‑766‑9563) for assistance.
Occasionally a foreign object may enter the auger/impeller
housing and jam the auger, breaking the shear bolts which
secure the auger to the shaft. This allows the auger to turn
freely on the shaft which may help prevent damage to the
gearcase and its components.
m
WARNING!
Always turn off the snow blower's motor and
remove the batteries prior to replacing shear bolts.
1. Align shear bolt holes in auger with shear bolt holes in the
shaft.
2. Drive shear bolt through hole. If shear bolt was broken this
will drive remaining part from shaft (Fig. 28).
3. Secure shear bolts with the nuts, with the 10 mm end of
either open end wrench (Fig. 28).
Fig. 28
Shear bolts
Replacing Auger Blades
1. Disassemble the auger and impeller assembly by
removing the bolts from the sides of the auger housing
with the 12 mm open end wrench (Fig. 29), and pull out
the auger and impeller assembly (Fig. 30).
+ Sun Joe customer service
® ®
10 mm wrench end
Nuts