Greenlee 881 Manual De Instrucciones página 8

Assembly and Operation Instructions
881 and 881CT—Floor Operation (cont'd)
10. Attach the hose (L) to the pump and ram.
11. Make sure the shoe and follow bar grooves are
clean. Insert the conduit into the bender.
12. Set the conduit into the groove of the shoe. Rotate
the shoe as necessary to align the saddle with the
shoe. Position the saddle so the saddle insert is
toward the operator, as shown. Attach the saddle to
the shoe with the saddle pin unit (M); secure the pin
unit with the hitch pin clip (E).
Note: Align the bending mark on the conduit with
the outside edge of the saddle insert.
Greenlee Tools, Inc.
881 and 881CT Hydraulic Benders
Follow the instructions and safety information
supplied with your hydraulic pump.
The instructions provided here apply to Greenlee
960 (shown in the illustrations) and 980 (not shown)
hydraulic pumps only.
Bending Mark
Saddle Insert Saddle
13. Rotate the pump control lever counterclockwise.
Activate the hydraulic pump until the shoe just con-
tacts the conduit. Check that the saddle and follow
bar are snug. Be sure that the follow bar contacts
the saddle. Be sure that the bending mark on the
conduit is aligned with the front edge of the saddle
insert. Calibrate the bender (refer to "Calibrate
Bender Before Bending" under "Table 3—Ram
Travel").
Activate the hydraulic pump to begin the bend.
14. 10° of bend.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070