Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.3 Mounting the cutting chain assembly
The cutting chain assembly consists of:
- Guide rail (6)
- Cutting chain (9)
- Sprocket wheel (10)
Use the following procedure to mount / replace
the cutting chain assembly:
1.
Pull out the power plug of the machine.
2.
Put down the cable where you can see it.
3.
Using the 4-mm [0.16-in] Allen key attached to
the machine, turn the threaded pin (11) to
release the tension of the cutting chain.
4.
Loosen the two knurled screws (3) at the
same time and remove the chain guard (12).
5.
Using the 8-mm [0.32-in] Allen key attached to
the machine, turn the fillister head screw (13)
counterclockwise to loosen it.
12
Fig. 3: Parts of the cutting chain assembly
Fig. 4: Releasing the tension of the cutting chain
Fig. 5: Removing the chain guard
LS103Ec
02/2022
Publicidad
Tabla de contenido
