Installation; Selection Of Installation Equipment - Infiniton IND-4TBM Manual De Instrucciones

Heating stops suddenly
during operation and the
display flashes "u".
Heating zones of the
same side ( Such as the
first and the second
zone ) would display "u" .
Fan motor sounds
abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the induction
hob.

9. Installation

9.1 Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated
work surface material (Wood and similar fibrous or hygroscopic material shall not be used as work
surface material unless impregnated) to avoid the electrical shock and larger deformation caused by
the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
should be at least 3mm.
L(mm) W(mm) H(mm)
Pan Type is wrong.
Pot diameter is too
small.
Cooker has
overheated;
The power board and
the display board
connected failure;
The display board of
communicate part is
damaged.
The Main board is
damaged.
The fan motor is
damaged.
D(mm) A(mm) B(mm)
18
Use the proper pot
(refer to the instruction
manual.)
Unit is overheated. Wait
for temperature to
return to normal.
Push "ON/OFF" button
to restart unit.
Check the connection.
Replace the display
board.
Replace the power
board.
Replace the fan.
X(mm) F(mm)
Pan detection
circuit is damaged,
replace the power
board.