RIDGID R4093 Manual Del Operador página 18

ASSEMBLY
WARNING:
If the inner washer has been removed, replace it
before placing wheel on spindle. Failure to do so
could cause an accident since the wheel will not
tighten properly. Never use wheels that have open-
ings, grooves, or teeth on this tool.
 Wipe a drop of oil onto the washer where it contacts the
cutting wheel.
 Place an outer washer onto the spindle. The double "D"
flats on the washer align with the flats on the spindle. Be
sure the hollow side of the washer is against the cutting
wheel.
 Place wheel nut on spindle.
 Depress the spindle lock button and rotate the cutting
wheel until the spindle locks.
 Using the wheel wrench provided, tighten nut securely.
Release the spindle lock button.
 Close and lock the wheel guard.
INSTALLING SPLASH GUARD ASSEMBLY
See Figures 26 - 28.
The splash guard on this saw is a two-part assembly.
Attaching rear splash guard:
 Remove screw and washer from the back of the motor
head.
 Line up rear splash guard holes with screw hole and post
on back of cutting wheel guard, as shown.
 Insert screw through washer and splash guard then thread
into screw hole.
 Tighten securely. Be careful not to overtighten.
Attaching side splash guard:
 Install side splash guard over the rear splash guard.
 Insert post, located on side of cutting wheel guard,
through hole in side flap of guard.
 Settle splash guard grooves over ridges in cutting wheel
guard.
 Repeat with other side.
 After assembly is complete, pull rear splash guard out-
ward so flaps rest over side splash guard.
REAR
SPLASH
GUARD
SIDE SPLASH
GUARD
18 — English
SCREW HOLE
WASHER
REAR SPLASH
POST
GUARD
POST RIDGE
HOLE
SCREW
Fig. 26
GROOVE
SIDE SPLASH
GUARD
Fig. 27
REAR SPLASH
GUARD
Fig. 28