RIDGID R4093 Manual Del Operador página 22

ASSEMBLY
TO CLOSE/OPEN THE WSUV STAND
See Figures 36 - 38.
NOTE: Be sure the frame is secured to the latches before
closing.
 Lock sliding table and frame.
 Remove water tray extensions and any workpieces from
the tool. (See figure 61.)
 Lower the wheel and secure by locking the saw head in
place using the lock knob and lock pin.
To close the WSUV stand:
 At the same time, step on the release lever, grasp the
grips, and lift the handles up and away from the body.
 Push the inner leg assembly until the release lever clicks
and locks into place.
To move the WSUV stand:
 Holding the grips firmly, pull the handles toward you until
the WSUV stand and saw are balanced on the wheels.
 Push the saw to the desired location then either open the
WSUV stand for saw operation or store the saw in a dry
environment.
INNER LEG
ASSEMBLY
22 — English
LOCK PIN
LOCK
KNOB
RELEASE
LEVER
Fig. 36
Fig. 37