Tools Needed - RIDGID R4093 Manual Del Operador

FEATURES
KNOW YOUR TILE SAW
See Figure 4.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
10 in. TILE CUTTING WHEEL - A 10 in. tile cutting wheel
is included with your saw.
WARNING:
Do not use wheels rated less than the speed of
this tool. Failure to heed this warning could result
in personal injury.
BEVEL LOCK KNOB - The bevel lock knob securely locks
the saw head at any bevel angle between 0º and 45º. It is
recommended that you only make bevel cuts at 0˚, 22.5˚,
and 45˚ angles.
WARNING:
Making bevel cuts at angles other than 0˚, 22.5˚,
and 45˚ angles could cause the cutting wheel to
come in contact with the sliding table resulting in
damage to the unit and/or possible serious injury.
ELECTRIC BRAKE - An electric brake has been provided
to quickly stop wheel rotation after the saw is turned off.

TOOLS NEEDED

The following tools (not included or drawn to scale) are needed for assembly and alignment:
FRAMING SQUARE
PHILLIPS SCREWDRIVER
MICRO-CUT FENCE SUPPORT - This machined ledge
helps prevent tile from cracking.
MITER GUIDE - The easy-to-read indicator on the miter
guide shows the exact angle for a miter cut with detents at
0°, 22.5°, and 45°.
ON/OFF SWITCH - This saw has an easy access power
switch located on the saw arm. To lock the switch, install a
padlock (not included) through the hole in the switch. When
the lock is installed and locked, the switch is inoperable.
Store the padlock key in another location.
RIP FENCE STORAGE - The tile saw has a convenient stor-
age area to store the rip fence when not in use.
SLIDING TABLE - The sliding table allows the user to slide
the workpiece into the cutting wheel for accurate cuts.
S P L A S H G U A R D A S S E M B LY w i t h T O O L L E S S
REMOVABLE SIDE GUARD - The splash guard helps
contain spray and mist.
WATER PUMP - The water pump provides water to the
cutting wheel.
WATER TRAY EXTENSIONS - When cutting larger tile, the
extensions keeps work area cleaner and drier.
WRENCH STORAGE - The saw has a convenient storage
area specifically designed for the wheel wrench (back of
the saw arm) and the hex key (below the bevel lock knob).
WSUV (WET SAW UTILITY VEHICLE) STAND - Attached to
the saw base, the stand opens and closes with ease making
transportation simple.
8 — English
ADJUSTABLE WRENCH
10 mm, 13 mm and 17 mm
WRENCH
Fig. 5